The latest NX 40mm Stainless XPERT is now available from X-Pole!
A significant benefit of the Stainless pole is that people who suffer from metal allergies can still pole dance!
Key changes to the X-Poles are; New X-Joint with locking Key - this is a big improvement over the previous pin system and makes the X-Joints even more rigid. You can feel the difference.
- New improved X-Joint locking action to ensure joints are really tight.
- New larger Hex Key with rubber cover to make tightening easier.
- Fixed adjuster cover – no need to remove the cover any more to adjust or lock the adjuster.
- Special adjuster alignment system - to stop adjuster damage.
- New marking system to stop over adjustment and simplify installation.
- Increased screw sizes throughout – no more rounding off of critical screws
- Improved static and spinning lock with larger flattened screw ends
- New improved polishing - higher grip on all poles
- New strengthened Carry Cases featuring pockets for the pole tubes and not Velcro
- New instructions with more drawings – makes installation clearer
- New environmental boxing and inner tray - all paper with no foam!
If your ceiling height is above 2745mm you will require a further extension piece. Extensions needed for these new (NX) model sets are (NE) extensions found here: X-Pert Extensions (NE)
If you aren't sure what length extension you need, check out our height calculator here.
Recommended Maximum Height: 3.35m - extra NE extensions and NJ joints will need to be purchased.
The X-Pert set contains:
- Micro Base Plate - smaller base for minimum contact and maximum support
- Main Pole A (bottom pole) with attached height adjuster rod and all NEW super-simple adjuster cover - Metal (not plastic) Adjuster Cover simply threads into place creating a smooth pole from top to bottom. With no sharp edges or threads to scrape arms or legs, you can use the entire pole with confidence.
- Main Pole B (top pole) - Only the Main Pole A and Main Pole B are needed for ceiling heights of 2235mm - 2375mm
- Spinning/Static option - lock the pole for static and unlock for spinning.
- 125mm extension - Attach this extension for ceiling heights 2360mm - 2500mm
- 250mm extension - Attach this extension for ceiling heights of 2485mm - 2620mm
- Combine both the 125mm with the 250mm for ceiling heights of 2610mm - 2745mm
- 1x 180mm NEW X-Joint - Comes attached to the 125mm extension and used with the smallest extensions that are closest to the ceiling
- 2x 200mm NEW X-Joints - Used to connect all larger pole pieces
- Top Adapter - Attaches to the upper most pole piece/extension
- Upper Support Dome - a wide dome that is able to grip a large surface area of the ceiling for extra stability and support (comes with a silicone ring to protect your ceiling)
- Hex Key Set - The ONLY tools you will need to properly set up your X-Pert!
- 2x Carry Cases - One case is used for the pole pieces/extensions and the second is used for the micro base plate and upper support dome.
- Photo Display Manual
Please note that the XS/XX extensions and XJ joints will not work with this pole set - however you can use a NJA adapter joint to mix the 2 designs if required.
PLease call the office on 022 101 9141 if you require further assistance.
