XPERT (NX) Pole Set - 40mm Chrome

The latest NX 40mm Chrome XPERT is now available from X-Pole! 

The 40mm (1.5") pole is slimmer than the standard 45mm and 50mm poles whilst retaining a highly durable and robust design that is synonymous with all X-Pole products. A significant benefit of the new 40mm pole is that tricks can become easier to perform, increasing dancer's confidence, especially for those with small hands! The 40mm pole gives a unique new dynamic to performances and is already being met with huge praise from the industry.

Key changes to the X-Poles are; 

• New X-Joint with locking Key  - this is a big improvement over the previous pin system and makes the X-Joints even more rigid. You can feel the difference.
• New improved X-Joint locking action to ensure joints are really tight.
• New larger Hex Key with rubber cover to make tightening easier.
• Fixed adjuster cover – no need to remove the cover any more to adjust or lock the adjuster.
• Special adjuster alignment system  - to stop adjuster damage.
• New marking system to stop over adjustment and simplify installation.
• Increased screw sizes throughout – no more rounding off of critical screws
• Improved static and spinning lock with larger flattened screw ends
• New improved polishing  - higher grip on all poles
• New strengthened Carry Cases featuring pockets for the pole tubes and not Velcro
• New instructions with more drawings – makes installation clearer
• New environmental boxing and inner tray - all paper with no foam!

If your ceiling height is above 2745mm you will require a further extension piece. Extensions needed for these new (NX) model sets are (NE) extensions found here: X-Pert Extensions (NE) 

If you aren't sure what length extension you need, check out our height calculator here.

Recommended Maximum Height: 3.35m - extra NE extensions and NJ joints will need to be purchased.

The X-Pert set contains:

• Micro Base Plate - smaller base for minimum contact and maximum support
• Main Pole A (bottom pole) with attached height adjuster rod and all NEW super-simple adjuster cover - Metal (not plastic) Adjuster Cover simply threads into place creating a smooth pole from top to bottom.  With no sharp edges or threads to scrape arms or legs, you can use the entire pole with confidence.
• Main Pole B (top pole) - Only the Main Pole A and Main Pole B are needed for ceiling heights of 2235mm - 2375mm
• Spinning/Static option - lock the pole for static and unlock for spinning.
• 125mm extension - Attach this extension for ceiling heights 2360mm - 2500mm
• 250mm extension - Attach this extension for ceiling heights of 2485mm - 2620mm
• Combine both the 125mm with the 250mm for ceiling heights of 2610mm - 2745mm
• 1x 180mm NEW X-Joint - Comes attached to the 125mm extension and used with the smallest extensions that are closest to the ceiling
• 2x 200mm NEW X-Joints - Used to connect all larger pole pieces
• Top Adapter - Attaches to the upper most pole piece/extension
• Upper Support Dome - a wide dome that is able to grip a large surface area of the ceiling for extra stability and support (comes with a silicone ring to protect your ceiling)
• Hex Key Set - The ONLY tools you will need to properly set up your X-Pert!
• 2x Carry Cases - One case is used for the pole pieces/extensions and the second is used for the micro base plate and upper support dome.
• Photo Display Manual

Please note that the XS/XX extensions and XJ joints will not work with this pole set - however you can use a NJA Adapter joint to mix the 2 designs if required.

Please call the office on 022 101 9141 if you require further assistance